Glowing Trims
Make your armor trims and elytra trims glow in the dark.
Put a normal trim on a piece of armor or an elytra, then give it glow ink. The trim keeps its pattern and material, but now it shines at full brightness with a soft bloom, and it lights up the area around you.
How it works
- Trim your armor or elytra as usual at the smithing table.
- Go back to the smithing table: put the trimmed piece in the base slot and a glow ink sac in the addition slot. Leave the template slot empty.
- Take the result. The trim now glows.
- Only once: a piece that already glows gets no result (the table shows its red X).
- Take it off: a normal ink sac in the addition slot removes the glow. The trim stays.
- Change the trim: a new material or pattern removes the glow, so you decide again.
- Works on every piece of armor, on armor stands, and on the item in the inventory, in your hand, on the ground and in item frames.
Looks great with shaders
The glow is drawn as an emissive layer, so shader packs add real bloom to it. Tested with the Prismarine shader. Without a shader the trim is still drawn at full brightness.
Light in the dark
With Sodium Dynamic Lights installed, a worn glowing trim also lights up its surroundings (light level 6, you can change it).
Works with Elytra Trims
Elytra Trims lets you put trims on elytras. Glowing Trims makes those glow too, with the same recipe. Tested with Elytra Trims 3.9.1. Both mods are optional, Glowing Trims runs without them.
Config
config/glowingtrims-client.toml (client only)
lightLevel: light given to the surroundings, 0 turns it off (needs Sodium Dynamic Lights)glowLayer: draw the extra glow layer on worn trimsglowStrength: 1 is a soft glow, 3 is very brightitemGlow: glowing trims also shine on the item itself
Notes
- Install on both client and server. Players without the mod on a server only miss the glow.
- Minecraft 1.21.1, NeoForge 21.1.x.
- Newer Elytra Trims versions do not run with NeoForge 21.1.209, use 3.9.x.