Realistic Block Physics

Warning: Some configuration values will be reset upon loading this version for the first time.

Fixes

• Fixed the world definition "Physics.BlockDefinitionBlacklist" configuration being placed at the top-level rather than in the Physics category [resets config value]
• Fixed the world definition "Defaults.DefaultBlocksBlacklist" configuration being placed at the top-level rather than in the Defaults category [resets config value]
• Fixed an issue which, when a default block definition was specified for a dimension, would apply default physics to blocks within definitions that were already blacklisted from that dimension via the Definition.Physics.BlockDefinitionBlacklist configuration
• Fixed an issue which would limit beams protruding from pillars to be a maximum length of 8 blocks on the "realistic" engine, despite their support strength
• Fixed an issue on the "simple" engine where blocks with a block definition, but no collision bounds, would cause the ground beneath them to fall if there was an air pocket
• Fixed an issue where setting the "BeamStrength" value of a block definition to 1.0 would cause the blocks to float when not supported

Enhancements

• Widened the scope for calculating additional cave strengthening.