create_controlling-neoforge-0.2.7+1.21.1.jar
Curse Maven Snippet
What's new
0.2.7
Two of the most requested features: copycat control consoles, and cable support for Drive-By-Sable.
New: Copycat Control Console. A console that accepts blocks and uses it texture, just like other copycat blocks.
- Craft it like the Control Console, with a Copycat Panel in place of the Andesite Casing.
- Right-click it with a block and the body takes that block's look. Any block Create's own copycats accept will work.
- Right-click with the same block again to turn it (a log's axis). Right-click with a different block to swap it; the old one comes back.
- To go back to bare zinc, open the designer with nothing selected and press Take Block.
- The block travels with the console when it is picked up or broken.
- Copycat consoles join into one desk only when they copy the same block.
- The face plate stays the standard one, and the trim of the parts stays zinc whatever the block.
Known limits: a copied block's connected textures don't connect across consoles, and glowing blocks give off no light.
New: Drive-By-Sable cables (1.21.1 only). With Drive-By-Sable installed, every control, lamp, meter and nixie readout on a console is a cable endpoint of its own. No frequency needed, and no Redstone Links sticking out of your vehicle.
- Hold the Cable, click a button, switch, knob, slider or lever to pick it as the source, then click what it should drive: a block face, or a lamp or meter on any console.
- Lamps, meters and nixie readouts take a cable the same way, from a console control or from anything else Drive-By-Sable can use as a source.
- The cable carries the control's exact value, 0 to 15.
- While you hold the Cable or the Cable Cutter, clicking a part only wires it. Knobs and sliders don't move, and you don't need to sneak.
- A part that also has a frequency keeps using it. A control sends on both, and a lamp or meter shows whichever is stronger.
- Aim at a part: the bare face of a console takes no cable. Each part is its own channel, named after the part with a short code, such as
Knob 3FA2. - Removing a part in the designer drops its cables. The cable items are not returned.
This needs Drive-By-Sable r2.1.0 or newer. The original Drive-By-Wire and its Sable port are not supported, and there is no cable support on 1.20.1, where Drive-By-Sable does not exist.
Feedback wanted: tell us how cables behave on your vehicles, on the issue tracker.
This mod has no additional files