PetAssist

Classic Era · Warlock & Hunter

PetAssist sends your pet to attack the same target as soon as you cast from the action bar. In Classic, a pet on Defensive often sits idle until you or the pet take damage — this addon fixes that without hand-writing /petattack on every spell.

What it does

Pet assist on cast
Press a damage spell or DoT on the bar → the pet gets /petattack together with your cast.

SoftCC Guard (on by default)
On Fear, Banish, Howl of Terror, Death Coil, traps, and similar CC, the pet is set to Passive + Follow so it does not break crowd control. Your next damage spell sends it back in.

Recall
Optional keybind to pull the pet back anytime (/petpassive + /petfollow).

Modes

• harm (default) — pet on damage, DoTs, and curses; not on stones, buffs, or utility. CC spells use SoftCC instead of sending the pet in.
• all — pet logic on every action-bar button.
• custom — pet everywhere except spells you add with /pa block.

Setup & tips

1. Target an enemy and cast from the action bar (not the spellbook).
2. Open settings: Esc → Options → AddOns → PetAssist or /pa config.
3. After moving spells on the bar, run /pa refresh out of combat.

Works with Blizzard bars, Dominos, Bartender4, and ElvUI.

Commands

/pa · /pa on|off · /pa config · /pa mode harm|all|custom · /pa softcc on|off · /pa recall KEY · /pa refresh

License: MIT
Source: github.com/nightdread/PetAssist