CopperWire Components

This mod gives you several new additions to Minecraft's redstone system:

Banner with all components shown

The New Components

CopperWire Image

CopperWire - The core component. This is a Redstone Dust compatible block that gives you 100% of the control over where it will connect. It also lets you allow 2 different signals to cross within the same block, as well as run a signal up a wall. The biggest feature, however, is that it will maintain the same redstone signal level for 16 blocks before decaying by 1. This allows for designing circuits that make valuable use of the redstone signal level. This lets 1 copper wire carry the equivalent of 4 binary redstone signals on a single line! On top of all of that, Copper Wire can even be placed underwater. To change which sides are connected, just click near that edge of the wire's surface. If all 4 sides are enabled, you can click the center to toggle between fully connected and crossing modes.

CopperLantern Image

CopperLantern - This works parallel to a torch, except that it can emit all redstone values. When mounted on a solid block, the torch gives off the inverse value of whatever power is supplied to the block.

CopperLight Image

CopperLight - Much like the Redstone Lamp, this light turns on when supplied with a non-zero redstone signal. However, the color produced depends on the redstone signal value. That makes this a 16 color light!

CopperPowerSource Image

CopperPowerSource - Imagine wrapping a Redstone Block in copper wire and being able to control the redstone value it emits. That's precisely what this block is.

CopperPowerMeter Image

CopperPowerMeter - Just set this block down beside any piece of Redstone Dust or Copper Wire, and it will tell you what the current value is. It can even be placed on top of dust and wires to get the value.

CopperDiode Image

CopperDiode - A Redstone Repeater is great for boosting the redstone value to 15. In the same way, the Copper Diode boosts the internal signal being carried without modifying the redstone value so that copper wire can carry the signal for another 16 blocks.

CopperSignalLock Image

CopperSignalLock - This is a single component latch designed after the repeater, only in reverse and with the ability to preserve whatever signal state it is fed. Feeding any non-zero input into either side will enable the CopperSignalLock to store the signal state at it's input.

How It Works

Copper Wire introduces a new state called a "step". When read from an active power source or redstone gate, this step value is initialized to 15. Just as Redstone Dust loses 1 value point for each block that it carries a signal, Copper Wire loses 1 step value for each block traveled. When the step value reaches 0, the next block will see the step go back to 15 and the redstone value finally lose 1... unless losing 1 causes the redstone value to go to 0. In that case, step will also be zero. Since the step value on Copper Wire does not affect the displayed state, and there are multiple potential step values for each instance, the step value is not directly part of the state of the block. It is instead kept in an entity that manages the multiple values that the block can maintain. This keeps the number of states from ballooning out of control and upping the memory requirements too much.

Both Copper Wire and Diode allow you to select which directions are active. Simply tapping use on that quadrant of the block toggles the corresponding side on and off. With the Copper Wire, once all 4 sides are toggled on, tapping use on the middle of the block will toggle "hop" mode, allowing the east/west direction to carry a different signal than the north/south direction. Copper wire can also be placed on a block vertically above another piece of copper wire that is vertical on that same side.

The Copper Power Meter and Source have the ability to emit/display the signal in copper step units as well as redstone value units. The default is Redstone units. To display the signal in copper step units, put a switch on the side of the block and turn it on.